FT 130A
- Extreme Response
- BEC regulated power supply with multiple protection guarantees
- Industrial-grade professional procedures, safe and reliable
- Highly reliable start algorithm, no fear of headwind starting
- The throttle is anti-phase loss and fast throttle response to reduce the risk of crashes
- Highly intelligent, adaptive working parameters
- Secure matching
- Specification: 130A 6~14S
Features
- The direction of rotation can be set by software
- High-quality components, reliable performance, low internal resistance, MOS, instantaneous current resistance
- The serial port outputs real-time data such as power supply voltage, motor speed, current, ESC temperature and debugging data.
- Shielding signal lines reduces interference
- Optoelectronic isolation signal input and output interfaces isolate interference
- Lightweight design, simple and easy to use, stable and reliable, strong anti-interference ability, good speed regulation performance
protective function
- Low voltage protection: off by default (can be customized on).
- High voltage protection: prohibit the motor from starting when the power supply voltage exceeds the allowable value.
- Startup protection: If the startup is unsuccessful, the startup current will be limited, and the startup will be restarted automatically.
- Stall protection: If a stall occurs during normal operation (usually caused by external force), try to restart (note that the stall may damage the ESC when the throtor is high).
- Over-temperature protection: When the temperature exceeds 125°C, the maximum output power is slowly reduced, up to 40% of the full throttle power, and the original power is restored after the temperature is reduced.
- Over-current protection: limit the peak current and do not exceed the limit value.
- Overload Protection: When an overload is identified on the motor, the maximum throttle is limited to protect the powertrain.
- Loss of control protection: 200ms after the loss of signal gradually reduce the output power, in 1~2 seconds for rapid throttle reduction to less than 50%, and then slowly reduce the throttle to stop.
Basic parameter
- Model：FT 130A
- Voltage:6~14S
- Size:92*40.4*25.5mm
- Weight：171g (including cable)
- Continuous operating current：100A (specific heat dissipation)
- Instantaneous operating current (less than 3 seconds)：180A
- Throttle response time:100ms (default, customizable)
- 0~100% response time.0.6 seconds (partial power)
- Throttle Refresh Rate:50~500Hz (100~400Hz recommended)
- Standby power consumption：≤10mA@60V
- Throttle travel range:1000–2000 (default value)
- BEC:7.4V 10A/5V 2A开关降压
Drawings
Test conditions: ambient temperature 30 ℃, power supply voltage 48V, blowing air cooling, data for reference only
| load test | Testing time | starting temperature | result |
|---|---|---|---|
| 60A | 7 minutes. | 31℃ | Normal, MOS temperature 61°C |
| 80A | 7 minutes. | 31℃ | Normal, MOS temperature 70°C |
| 100A | 7 minutes. | 31℃ | Normal, MOS temperature 73°C |
* Specific heat dissipation conditions (low ambient temperature, blowing air, auxiliary heat dissipation surface, feedback MOS temperature below 125℃), can run continuously 100A, continuous high temperature work will reduce the service life of the ESC, it is recommended to keep the feedback MOS temperature below 105℃ in practical applications.